22B-B5P0F104

22B-B5P0F104

保護氣體是通過噴嘴口以的壓力射出到達工件表面的，噴嘴的流體力學形狀和出口的直徑大小十分重要。它以足夠大以驅使噴出的保護氣體覆蓋焊接表面，但為了有效保護透鏡，阻止金屬蒸氣污染或金屬飛濺損傷透鏡，噴口大小也要加以限制。流量也要加以控制，否則保護氣的層流變成紊流，大氣卷入熔池，終形成氣孔。

為了提高保護效果，還可用附加的側向吹氣的方式，即通過一較小直徑的噴管將保護氣體以的角度直接射入深熔焊接的小孔。保護氣體不僅抑制了工件表面的等離子體云，而且對孔內的等離子體及小孔的形成施加影響，熔深進一步增大，獲得深寬比較為理想的焊縫。但是，此種方法要求控制氣流量大小、方向，否則容易產生紊流而破壞熔池，導致焊接過程難以穩定。

6）透鏡焦距。焊接時通常采用聚焦方式會聚激光，一般選用63~254mm（2.5”~10”）焦距的透鏡。聚焦光斑大小與焦距成正比，焦距越短，光斑越小。但焦距長短也影響焦深，即焦深隨著焦距同步增加，所以短焦距可提高功率密度，但因焦深小，保持透鏡與工件的間距，且熔深也不大。由于受焊接過程中產生的飛濺物和激光模式的影響，實際焊接使用的短焦深多為焦距126mm（5”）。當接縫較大或需要通過加大光斑尺寸來增加焊縫時，可選擇254mm（10”）焦距的透鏡，在此情況下，為了達到深熔小孔效應，需要更高的激光輸出功率（功率密度）。

APPLIED MATERIALS WPLATE PERF 125 MM OXIDE 0020-10122

Applied Materials 0150-75028 EMC COMP CABLE D.C AMAT

Applied Materials 0090-77207 HARNESS LEVEL SW AMAT

Applied Materials 0150-02649 CABLE O2 SENSOR AMAT

AMAT Applied Materials Gas Line P/N 0050-14943 Rev A

AMAT Applied Materials Gas Line P/N 0050-32272 Rev P1

AMAT Applied Materials Gas Line P/N 0050-08270 Rev P2

AMAT Applied Materials Gas Line P/N 0050-61916 Rev 001

AMAT Applied Materials Gas Line P/N 0050-76984 Rev A

AMAT Applied Materials Gas Line P/N 0050-33639 Rev A

AMAT Applied Materials Gas Line P/N 0050-39383 Rev A

AMAT Applied Materials Gas Line P/N 0050-76036 Rev A

Applied Materials Water cooled RF Coil (2) AMAT

NEW AMAT APPLIED MATERIALS VACUUM FITTING 

Applied Materials AMAT Cooling Pad Wldmt

Applied Materials AMAT Gas Ring wldmt

Applied Materials AMAT SLDMT Tube Assy 828-14-300 (3)

Applied Materials OPTO Detector Card Assy 0100-00014

AMAT Applied Materials Centura Ring 0200-35320

Applied Materials 0100-20073 LLBL Wafer Detector Board

Applied Materials 0100-01858 Endura Logic Interface

Applied Materials Operator Control Panel 0010-21745

Applied materials 0100-11002

Applied materials analog output bd assy 0100-11001

AMAT Vacuum Pump 40' Cables Kit 40-FT Applied Materials

Applied Materials AMAT Cryopump Valve, 3870-02260

Applied Materials AMAT Duplex Bearings, 0190-77112

Applied Materials PWB Assy Prom Triple Page 670794

Applied Materials AMAT VCR Tee Weldment, 0050-42819

Applied Materials AMAT VCR Tee Weldment, 0050-49910

Applied Materials AMAT VCR Weldment, 0050-75021

Applied Materials AMAT 30 SLM Gas Filter, 4020-00084

APPLIED MATERIALS 0190-40016 MDC KIV-150-P-990990 VALVE

Applied Materials AMAT Kalrez O-Ring, 3700-02569

Applied Materials AMAT Fujikin Valve, 3870-01603

Applied Materials AMAT KALREZ SAHARA O-RING, 3700-03768

APPLIED MATERIALS (AMAT) RING, RETAINING FLANGED 300mm

APPLIED MATERIALS (AMAT) IDLER ROLLER P/N 0021-17835

APPLIED MATERIALS (AMAT) BELLOWS, SLIT DOOR PRODUCER 

APPLIED MATERIALS 3020-01223 NEW

Applied Materials 0140-00726 H/A LAMP INTEGRATION LTESC

Applied Materials 3870-02073 1/4" VCR Monoblock Valve

APPLIED MATERIALS 0090-20004 VEXTA A3723-9215 MOTOR 

Expedited shipping available

Applied Materials AMAT Flow Restrictor, 3300-08546

APPLIED MATERIALS 0140-00357 HARNESS ASSY, 208VAC DIST

APPLIED MATERIALS 0100-76048 SAC CONTACTOR CONTROL BD.

Applied Materials AMAT 8" Pedestal, 0020-29719

Applied Materials AMAT DPS Weldment, 0050-31433

APPLIED MATERIALS 0140-77062 ROBOT WRIST ENCODER CABLE

Expedited shipping available

APPLIED MATERIALS 0090-77263 SENSORTECHNICS SQ 96612

APPLIED MATERIALS 1350-01197 SENSORTECHNICS SQ 96781

Applied Materials AMAT Chemraz O-Ring, 3700-02478

Applied Materials AMAT Chemraz O-Ring, 3700-01655

APPLIED MATERIALS 0010-02017 MANIFOLD ASSY D.I. RETURN 

Applied Materials AMAT Fujikin Valve, 3870-01767

Applied Materials AMAT KALREZ O-RING, 3700-01870

NEW APPLIED MATERIALS 0140-77288 CABLE, D5 IO, HARNESS

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0050-18680

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0050-70112

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0040-20106

Applied Materials AMAT Gimbal Flexure, 0020-79093

APPLIED MATERIALS QUARTZ COVER 125mm POLY, 0200-10044

APPLIED MATERIALS Ring, top, 125 mm flat, 0200-00157

APPLIED MATERIALS 0020-10771 150MM PERFERATED PLATE

APPLIED MATERIALS 0010-01039 ASSY, WAFER SENSOR AMAT

APPLIED MATERIALS CHAMBER INTERFACE BOARD 0100-35175

APPLIED MATERIALS CHAMBER INTERFACE BOARD 0100-35051

APPLIED MATERIALS CHAMBER INTERFACE BOARD 0100-35250

APPLIED MATERIALS CHAMBER ISOLATOR BOARD 0100-35065

APPLIED MATERIALS CHAMBER INTERFACE BOARD 0100-35054

APPLIED MATERIALS OPTO DETECT BOARD 0100-00014 REV. J

APPLIED MATERIALS TC GAUGE P.W.B BOARD 0100-00008 REV K

APPLIED MATERIALS 0190-35066 DUAL GAS LEAK DETECTOR

APPLIED MATERIALS 0190-35066 DUAL GAS LEAK DETECTOR

APPLIED MATERIALS 0100-35054 CHAMBER INTERFACE BOARD 

Applied Materials Digital I/O Board 0100-20003

Applied Materials Ceramic Lid AMAT #: 0200-00554

One-day shipping available

Applied Materials Lid Isolator, AMAT # 0200-00554

One-day shipping available

Applied Materials 0020-82818 APERTURE PLATE - AMI

Applied Materials 0020-86734 CLAMP, FILAMENT L/H

Applied Materials 0020-86733 CLAMP, FILAMENT R/H

Applied Materials 0020-31147

Applied Materials Support Cassette 0020-28435 Rev PB

APPLIED MATERIALS BOARD 5-CHANNEL HPRE 70512710000 NEW

Applied Materials Service Lift Kit 0242-29971

One-day shipping available

AMAT 0021-22602 B101 TI Cover ring 8" Applied Materials

APPLIED MATERIALS - 0200-01239

APPLIED MATERIALS 0100-09047 OZONATOR POWER SUPPLY BD.

Applied Materials 0150-02592 CABLE CENTURA SMIF AMAT

Applied Materials 0150-03542 CABLE MIRRA AMAT

Applied Materials Shield, Lower, 8", 0200-25077

Applied Materials Ring, Quartz, Pedestal, 0200-09217

APPLIED MATERIALS 0120-92712 MAINS SENSE 0110-90749 

AMAT Applied Materials Gas Line P/N 0050-08055 P1

AMAT Applied Materials Gas Line P/N 0050-08269 Rev P2

AMAT Applied Materials Gas Line P/N 0050-08986 Rev 001

AMAT Applied Materials Gas Line P/N 0225-34940 Rev E

Qty 3- AMAT Applied Materials Fujikin Valve

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0040-70165-A

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0040-20111

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0040-38849

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0050-28882 

NEW AMAT APPLIED MATERIALS VACUUM FITTING 0050-42135 

NEW APPLIED MATERIALS 0140-77286 CABLE, D3 IO, HARNESS

NEW APPLIED MATERIALS 0270-76174 FLOW RACK SHELF 24X24

APPLIED MATERIALS CRYO COMPRESSOR HOSE FITTING KIT AMAT

LOT 6 APPLIED MATERIALS CABLE ENDURA CTI-CRYO AMAT NEW

NEW APPLIED MATERIALS AMAT 0090-00494 SW, ASSY, PRES

NEW APPLIED MATERIALS 0100-11002 AMAT DIGITAL I/O BOARD

APPLIED MATERIALS FOCUS/DECEL CONTROL

Applied Materials Model: 0100-00014 Opto Detect PCBA 

APPLIED MATERIALS AMAT CRYO PUMP N2 PURGE 0090-90948

APPLIED MATERIALS PEDESTAL COVER 0021-20712 REVA

CARRIER,8" W/FLEX APPLIED MATERIALS - NEW

NEW AMAT APPLIED MATERIALS VALVE GATE SEAL 35 x 336mm

AMAT APPLIED MATERIALS CHAMBER EXHAUST POCKET SHIELD

APPLIED MATERIALS (AMAT) I/O VALVE ASSEMBLY 0010-09021

APPLIED MATERIALS (AMAT) RF RACK-CONT CABLE 0227-43743

Applied Materials 0020-98947 ELECTRODE, EH1 (SIC) - AMI

Applied Materials, Plasma Detect Board 0100-18035 AMAT

Applied Materials AMAT 1/2" Tubing, 20', 0190-77389

Applied Materials AMAT 1/4" VCR Valve, 3870-01745

Applied Materials 0040-97144 STRAP CONNECTOR F.G.

Applied Materials 0100-35127 PLIS-O3 I/O Distribution

Applied Materials Intelligent Interface 0100-09006

APPLIED MATERIALS 0190-09185 TYPE K TEMPERATURE PROBE

APPLIED MATERIALS INC. LINER, SIDE, P19500 AMI

APPLIED MATERIALS COVER, QUARTZ 6" POLY, 0200-00043

6 x APPLIED MATERIALS 0200-03314 KIT,LIFT PIN 170 , NEW

APPLIED MATERIALS 0140-09166 HARNESS ASSY DRYVAC PUMP 

APPLIED MATERIALS 0150-09196 ASSY CABLE SYSTEM TCS NEW

APPLIED MATERIALS 70209580000 MOTOR M06-LS08E SUPEROOR

APPLIED MATERIALS KIT,OVEN MK2 ASSY SPARE STD:REPLACES 

Applied Materials 0010-99166 MOVING CLIP ASSEMBLY